![]() Singh who had a close shave was undergoing treatment at a hospital, police said. Later, one of them pulled out a gun and allegedly shot at him, hitting his right hand, they said.Īrrests in the incident were yet to be made, they added. ![]() Singh was first assaulted by the gang after he stepped out of his car. Pankaj Singh, a resident of Howrah, was returning home with a few friends around midnight after attending an invitation when his car was stopped near Gorky Sadan in the upscale locality, they said. A businessman was shot at in south Kolkata's Elgin area in the early hours of Monday after his car was allegedly stopped by 15-18 men who were on motorcycles, police said.
0 Comments
![]() Take it from the one who’s heard the mighty voice of GodĪ living testimony of His death-defying touch, my name is Lazarus”ĩ) Andre Crouch “My Tribute” ( To God Be the Glory) If you think your little problem is too big for Him to solve My name is Lazarus, it feels good to be alive He said, “My name is Lazarus, could I testify? Jesus saith unto them, Loose him, and let him go. ![]() And he that was dead came forth, bound hand and foot with graveclothes: and his face was bound about with a napkin. John 11:43-44 And when he thus had spoken, he cried with a loud voice, Lazarus, come forth. Like all of his songs, this one makes the pages of Scripture come alive. Many of their songs are written by their own baritone Rodney Griffin. One of my favorite trios and one which I have had the pleasure to enjoy live on several occasions is Greater Vision. ![]() you must get the correct sample for the hardware in use. for example, FX3G_ModbusTCPServer_V100.zip or FX3U_ModbusTCPServer_V100.zip. To get started, log in to your MyMitsubishi account, search for "ModbusTCP" in the software downloads and download the correct version of sample code depending on the type of FX3 you are using. And in setting up, you are only actually going to give the module its IP Address and open 2 of it's 8 channels with TCP Support for reading/writing on the Port you specify.Īfter this has been done, the ModbusTCP functionality is handled by function block code running in the PLC that you edit and download with GX Works2. When using a FX3U-ENET, you connect the module, then must use FX-Configurator-EN to set it up. I guess this is why the came up with the -P502 version, so you could use the default Port 502.Īs an aside, FX3G-E PLC's with built-in Ethernet (in effect a built-in FX3U-ENET-ADP) also do NOT support ModbusTCP, however the FX3U-232MB-ADP Serial card does support ModbusRTU if you want a much lower cost alternative. The standard FX3U-ENET (the module that connects on the RHS Bus, not ADP version) has a limitation in that you cannot specify Ports below 1024. in any event your ADP version isn't going to work, so you will need to acquire either a FX3U-ENET or FX3U-ENET-P502. ![]() As correctly noted, the FX3U-ENET-ADP does NOT support ModbusTCP, however, you do not need to use the -P502 version either. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |